Influence of mechanical reinforcement of MgB2 wires on the superconducting properties

Monofilamentary MgB2-wires with a mechanical tough Nb/Cu/steel or Fe/steel sheath were prepared and characterized. The steel content was varied to investigate the reinforcement effect and the consequences for the superconducting properties of the wires, which were heat treated to achieve dense and homogeneous filaments. The use of Nb as first sheath layer, having a smaller thermal expansion coefficient than MgB2, requires the application of higher amounts of steel to achieve compressive pre-stress on the filament in comparison to Fe as first wall material. With raised steel content in the sheath the critical transport currents show field dependent significant critical current and irreversibility field degradations. First Ic vs. axial stress and strain experiments confirmed this observation of pre-stress induced degradations. Consequences for improved wires and for future applications will be discussed.Comment: 14 pages, 7 figures, 1 table; Submitted to Physica C; presentation at ISS-2001, Kobe Japa

K-shell x-ray spectroscopy of atomic nitrogen

Absolute {\it K}-shell photoionization cross sections for atomic nitrogen have been obtained from both experiment and state-of-the-art theoretical techniques. Due to the difficulty of creating a target of neutral atomic nitrogen, no high-resolution {\it K}-edge spectroscopy measurements have been reported for this important atom. Interplay between theory and experiment enabled identification and characterization of the strong $1s$ $\rightarrow$ $np$ resonance features throughout the threshold region. An experimental value of 409.64 $\pm$ 0.02 eV was determined for the {\it K}-shell binding energy.Comment: 4 pages, 2 graphs, 1 tabl

High transport currents in mechanically reinforced MgB2 wires

We prepared and characterized monofilamentary MgB2 wires with a mechanically reinforced composite sheath of Ta(Nb)/Cu/steel, which leads to dense filaments and correspondingly high transport currents up to Jc = 10^5 A/cm^2 at 4.2 K, self field. The reproducibility of the measured transport currents was excellent and not depending on the wire diameter. Using different precursors, commercial reacted powder or an unreacted Mg/B powder mixture, a strong influence on the pinning behaviour and the irreversibility field was observed. The critical transport current density showed a nearly linear temperature dependency for all wires being still 52 kA/cm^2 at 20 K and 23 kA/cm^2 at 30 K. Detailed data for Jc(B,T) and Tc(B) were measured.Comment: 21 pages, 13 figures, revised version, to be published in Supercond. Sci. Techno

Pressure Effect and Specific Heat of RBa2Cu3Ox at Distinct Charge Carrier Concentrations: Possible Influence of Stripes

In YBa2Cu3Ox, distinct features are found in the pressure dependence of the transition temperature, dTc/dp, and in DeltaCp*Tc, where DeltaCp is the jump in the specific heat at Tc: dTc/dp becomes zero when DeltaCp*Tc is maximal, whereas dTc/dp has a peak at lower oxygen contents where DeltaCp*Tc vanishes. Substituting Nd for Y and doping with Ca leads to a shift of these specific oxygen contents, since oxygen order and hole doping by Ca influences the hole content nh in the CuO2 planes. Calculating nh from the parabolic Tc(nh) behavior, the features coalesce for all samples at nh=0.11 and nh=0.175, irrespective of substitution and doping. Hence, this behavior seems to reflect an intrinsic property of the CuO2 planes. Analyzing our results we obtain different mechanisms in three doping regions: Tc changes in the optimally doped and overdoped region are mainly caused by charge transfer. In the slightly underdoped region an increasing contribution to dTc/dp is obtained when well ordered CuO chain fragments serve as pinning centers for stripes. This behavior is supported by our results on Zn doped NdBa2Cu3Ox and is responsible for the well known dTc/dp peak observed in YBa2Cu3Ox at x=6.7. Going to a hole content below nh=0.11 our results point to a crossover from an underdoped superconductor to a doped antiferromagnet, changing completely the physics of these materials.Comment: 6 pages, 5 figures Proccedings of the 'Stripes 2000' Conference, Rome (2000

Charge Transfer Of Hydrogen Ions And Atoms In Metal Vapors

Cross sections and equilibrium fractions for energetic H+, H−, and H0 in collisions with metal vapor targets have been compiled and evaluated. Both experimental and theoretical results are reported. Sources of errors are discussed, and recommended values for the data are presented. © 1985, American Institute of Physics for the National Institute of Standards and Technology. All rights reserved

Adiabatic normal zone development in MgB2 superconductors

A-priori knowledge of the normal zone development in MgB/sub 2/ conductors is essential for quench protection of applications. Therefore the normal zone propagation in a monofilament MgB/sub 2//Fe conductor under near-adiabatic conditions at 4.2 K has been measured and simulated. The results show normal zone propagation velocities up to several meters per second. In addition, by including the voltage-current relation into the computational model, the influence of the n-value on the normal zone propagation is determined. The simulations show that lower n-values suppress the normal zone propagation velocity due to lower heat generation in the MgB/sub 2/ filaments